Bar loading magazines can also load machining centres and revolving indexing machines!
Especially in the case of smaller prismatic workpieces it
would be better to work off bar stock than with saw-cut
individual parts. The bar can be loaded into the chuck
both through the spindle or through the machining section.
The loading cycles in this "endless loading technique"
are extremely short.
With its special loading magazine ILS-SB-TBL,
BREUNING IRCO offers a reliable solution with individual
adaptation to machining centres, horizontal or vertical
revolving indexing machines and special machines.
To enable processing of profiled materials, this
loading magazine is equipped with an indexed belt
conveyor and an automatic bar alignment system. Thanks
to the individually adaptable bar feed, the profiled material
can be pushed into the chuck in correct position. The fine
controllable servo drive of the one-step feed enables
controlled handling of the material bars.
It is often beneficial to work from the bar when
processing prismatic workpieces. Since this technology
is not all that common, BREUNING IRCO recommends
that interested parties contact it early on in their planning
for individual advice on the process.
ILS-SB-TBL special loading magazine for machining centres, revolving indexing machines and special machines
Especially in the case of smaller prismatic workpieces it
would be better to work off bar stock than with saw-cut
individual parts. The bar can be loaded into the chuck
both through the spindle or through the machining section.
The loading cycles in this "endless loading technique"
are extremely short.
With its special loading magazine ILS-SB-TBL,
BREUNING IRCO offers a reliable solution with individual
adaptation to machining centres, horizontal or vertical
revolving indexing machines and special machines.
To enable processing of profiled materials, this
loading magazine is equipped with an indexed belt
conveyor and an automatic bar alignment system. Thanks
to the individually adaptable bar feed, the profiled material
can be pushed into the chuck in correct position. The fine
controllable servo drive of the one-step feed enables
controlled handling of the material bars.
It is often beneficial to work from the bar when
processing prismatic workpieces. Since this technology
is not all that common, BREUNING IRCO recommends
that interested parties contact it early on in their planning
for individual advice on the process.
ILS-SB-TBL special loading magazine for machining centres, revolving indexing machines and special machines
NEWS |